Showing posts with label FLASHERS BY 555. Show all posts
Showing posts with label FLASHERS BY 555. Show all posts

19 LED flasher circuit using 555 IC

This project is a flashing led circuit powered by 555 timer IC.This
flasher circuit is composed of two versions, the simple led flasher 
that uses only two LED, and big flasher that consists 20  LEDs.

Simple LED Flasher circuit is powered from a 6V to 12V
battery and delivers a current of about 20mA to LED. The 
frequency of the flashing on both LED is controlled by 100K
potentiometer connected between the discharge and trigger pin
of 555 timer IC. The rate of flash ranges from 1blink per 2 
seconds up to 10 flashes per sec.
simple LED flasher schematic
Big LED flasher circuit is composed of 20 LEDs and uses transistors
as the driver and amplifier of the pulses generated by the 555 IC. The 
npn  general purpose type (9013, 2N222, etc), so is the pnp transistor
(9012, BC557, etc) If the supply voltage is 6V, R1and R2 =27 ohms 
while R1 and R2 = 200 ohms if supply voltage is 12V.

Big Led Flasher schematic
You can change the frequency of the flashes by changing the values
of resistors and capacitor using the 555 timer calculator.

If you planning to build up to 300 LED per group just replace the part of the schematic above with this. See diagram below. Power supply used is 12V.

Note: The type of LED can be of any color such as red, green, orange, yellow but not blue or white LED.
          Blue or white LED requires much higher forward voltage to light.


2 1.5V LED flasher by 555 timer IC

1.5V led flasher schematic


1.5V LED flasher by 555 timer IC
Part list:
R1- 5 kilo-ohms
R2- 5 kilo-ohms
C1- 100uF electrolytic capacitor
C2- 100nF
C3- 220uF electrolytic capacitor
C4- 47uF electrolytic capacitor
D- schotky or germanium diode but ordinary diode will do (1N4001)
LED- low power red, yellow or green LED

This simple LED flasher is powered by a CMOS type 555 timer IC that performs as a voltage doubler circuit to power up an LED. This 555 timer is operated in astable mode producing an output of approximately 1Hz square wave.Initially, at first cycle, the output of the ic at pin3 is approximately equal to voltage source (1.5V) which is not enough to light the LED. In this first cycle, the capacitor is charged. The output voltage of the next cycle is equal to the voltage source (1.5V) plus the capacitor voltage (approx 1.5V). Thus the total voltage from source to pin 3 is approximately equal to 3V, enough to light the LED.

555 timer project - simple LED Flasher
6V LED flasher schematic

This is a simple LED flasher uses  555 timer ic but unlike the flasher above, this circuit uses 6V rather than a 1.5V supply.Another difference is it uses an ordinary type of IC and not a cmos type.
the sample components are shown below using the 555 timer astable-mode formula

Frequency = 1.44/[C1(R1+2R2)]
duty cycle= (Thigh)(Frequency)
For
C=10uF
R1-1 kilo-ohms
R2-18 kilo-ohms
around 51% duty cycle is around 51% and frequency is 3.9Hz.
See 555 timer calculator to check this derived values.